HÄNY ECONEX 2402, Original Instructions Manual

Page: 139 / 228

139 / 226
ECONEX
®
- ECOCUT
®
- ECOVOX
®
PM1-101274 VERSION 06 / 15.02.2022
GB
2. SAFETY INSTRUCTIONS
2.1. Labelling
The safety instructions contained in these operating instructions, the national regulations on accident pre-
vention and the internal working, operating and safety requirements of the purchaser / operator must be
complied with under all circumstances to ensure safe operation of the pump at all times.
Non-compliance with some safety instructions may result in hazards for persons. These are labelled with the
following general hazard symbols.
DANGER
This symbol indicates danger of death or severe injury
WARNING
Draws attention to parts or types of handling that can lead to death or severe
injury
CAUTION
Draws attention to parts or types of handling that can lead to damage or se-
vere injury
ATTENTION
Accompanies safety instructions which can lead to risks for the device and its
functions in case of non-compliance
General hazard symbol
Indicates that hazardous electric voltage is present
Automatic operation: this symbol means that the machine / motor are being
controlled automatically and that it can therefore start operating at any time.
It is strictly forbidden to carry out servicing works or in any way to manipulate
the device unless the control has first been changed to manual and the power
supply has been switched off.
High noise emission, wear ear protection
Wear eye protection
Wear eye, ear and head protection
Labels directly appearing on the device itself, for example rotation direction
arrows, hazard warnings etc. must be complied with under all circumstances,
and they must be kept in legible condition.