Hanwha HCR-5, User Manual

Page: 37 / 206

Chapter 3 Installation
37
Chapter 3 Installation
The installer should install and operate the robot according to instructions of ISO
12100 and ISO10218-2 standards and comply with relevant requirements of
international standards such as ISO/TS 15066 and local laws and regulations.
The manufacturer is not responsible for accidents caused by noncompliance with
relevant requirements of international standards and local laws and regulations or due
to not performing review on the risk assessment as mentioned in Section 2.12.
3.1 Installation Locations
It is recommended to install the system in a place which meets conditions as follows:

A building with earthquake-resistant design

A place without water leaks
 A place free of flammability or explosives

A place that maintains the constant temperature and humidity

A place with little dusts
Caution
If the system is not installed in a recommended place, the performance and the life
span of the robot may be reduced.