User Manual
39
11.1.2 Recall setting
Used to select to recall from internal or from external. Same as store settings: select the
location, state name or external .csv setting file of the file to be recalled, press "Enter" to
confirm, and press "Recall" to execute recall.
11.1.3 Power-on setting
Press "Power On Setting" to select a state to be automatically recalled after power-on. You
can choose the default settings or user-specified settings. Press "SetPwrOn" to save the
settings. Users can also check "
□
Set this as power-on state." in "Store Settings" to set.
11.1.4 Restore default settings
Press "Set to Defaults" to restore the default settings.
11.2 I/O setting
IO setting is used to configure port parameters for remote control.
11.2.1 Digital I/O
Digital I/O is used to set the Pin1-Pin3 functions on the rear panel, and the other Pin is the
common ground terminal. Select Digital I/O, Pin 1-Pin3 can be set as general bidirectional
digital input and output. The data bits are allocated as follows:
Pins
3
2
1
Bit Weight
2 (msb)
1
0 (lsb)
Polarity: Set the Pin polarity to positive or negative.