Quick start
EN
HDG3000B User manual Copyright © Qingdao Hantek Electronics Co., LTD
12
4.4
Product Introduction
This chapter describes the front and rear panels and user interface of the machine.
4.4.1 Front Panel
Figure 4.3 Front Panel
1.
On/Off Switch
2.
Menu Softkey
Correspond to the left menus respectively. Press any softkey to activate the
corresponding menu.
3.
Function Keys
⚫
[Wave]: Select the waveform that the current channel will output.
⚫
[Setting]: Set the parameters of the waveform that the current channel will
output.
⚫
[Utility]: Auxiliary functions and system Settings. Used to set auxiliary function
and system parameters.
⚫
[Mod]: Enable generate modulated waveforms. A variety of analog and digital
modulation methods are provided to generate AM, DSB-AM, FM, PM, ASK,
FSK, PSK, BPSK, QPSK, 3FSK, 4FSK, OSK and PWM modulation signals.
⚫
[Sweep]: Enable generate sweep signals of "sine", "square", "ramp", "pulse",
"harmonic" and "arbitrary (except DC)".
⚫
[Burst]: Enable generate burst signals of "sine", "square", "ramp", "pulse",
"harmonic" and "arbitrary (except DC)".
⚫
[Trigger]: Manually triggered button. In sweep or burst mode, used to manually
trigger CH1 or CH2 to produce a sweep or burst signal (only when 1Output or
2Output is turned on).
⚫
[CH1/2]: Channel switching. Press this button to switch menu setting channel.
After selecting CH1, users can set the waveforms, parameters, and
configuration of CH1.
Summary of Contents for HDG3000B Series
Page 1: ...HDG3000B series Arbitrary waveform signal generator User Manual 2022 05...
Page 14: ......
Page 16: ......
