SCPI Programming Reference
HDG2000 Series Arbitrary Waveform Generator
71
Parameter
Typical Return
ON|OFF, default OFF
ON or OFF
Enable burst mode: SOURce1:BURSt ON
Output phase is set to 0 when burst is enabled.
To avoid multiple waveform changes, enable the burst mode after configuring the other burst
parameters.
The instrument will not allow the burst mode to be enabled at the same time that sweep or any
modulation mode is enabled. When you enable burst, the sweep or modulation mode is turned
off.
SOURce<n>:BURSt:TRIGger:SLOPe POSitive|NEGative
SOURce<n>:BURSt:TRIGger:SLOPe?
Select
POSitive or NEGative
of the external trigger signal to start sweep output.
Parameter
Typical Return
POSitive|NEGative, default POSitive
POSitive or NEGative
Select NEGative of the external trigger signal to start sweep output:
SOURce<n>:BURSt:TRIGger:SLOPe NEGative
5.2.5 CALibration Subsystem
The CALibration subsystem is used to calibrate the instrument.
CALibration:SETup <step>
CALibration?
CALibration:VALue <value>
CALibration:STORe
CALibration?
Performs a calibration using the calibration value (
CALibration:VALue
).
Parameter
Typical Return
none
0( pass) or +1( fail)
Calibrate using the current value: CALibration?
CALibration:SETup
should always precede the CALibration? query.
Modifies the volatile version of the calibration constants. Use
CALibration:STORe
to save these
constants in nonvolatile memory at end of calibration.
CALibration:SETup <step>
Configures the calibration step to be performed.
Parameter
Typical Return
Whole number, 1 to 8
none
Prepare for calibration step 5: CALibration:SETup 5