Application measurement
EN
HBT3000 series user manual
Copyright © Qingdao Hantek Electronic Co., LTD
26
Figure 6-2 Set sampling rate
6.1.2
Setting the average value
The average function refers to the function of outputting the average measured
value. By using this function, the deviation of the displayed value can be reduced.
Click on
[MEA] ->
Average
to set the average value. The average number of
choices is 1, 2, 4, and 8, as shown in the figure. The default setting is 1. Press the
corresponding soft key again to complete setting the average value.
Figure 6-3 Set average value
6.1.3
Trigger function
The trigger source function is used to set the trigger mode of the instrument.
Trigger sources include [Int], [Ext], and [Man].
Internal trigger: Automatically triggered internally (measured automatically).
External triggering: Measurement is carried out through external input triggering
signals. Set to external trigger, connect the TRIG terminal of the EXT I/O
connector on the rear panel to ISO_ COM short circuit, perform one
measurement.
Manual triggering: Measurement is carried out by manually inputting triggering
signals. Set to manual trigger, press the TRIG key to perform one measurement.
Click on
[MEA] ->
Trigger
in sequence to set the trigger source, as shown in the
figure. Press the corresponding soft key again to complete the setting of the
trigger source. The default setting is Int.
