Hansa C60 RX O&M Manual
– OM-015 Revision E 23/10/2019
© Hansa Chippers 2019
13
Troubleshooting
The chipper
won’t start
•
The engine oil level might be too low
The chipper is fitted with oil alert and will not start if the oil level is too low
Check the oil level and top up if required
•
The chipper is placed on a slope
The chipper is fitted with oil alert and will not start if the oil is not level
Move the chipper to level ground
Belt drive engagement will not work
•
The housing might be blocked
Turn engine off, disconnect the spark plug wire, ensure rotor has completely stopped, remove debris,
restart engine, then attempt to re-engage the belt drive
Drive belts squealing/smoking
•
Drive belts are loose/damaged
Turn the engine off, disconnect the spark plug wire, ensure rotor has completely stopped. Follow the
belt tensioning procedure on page 17
Turn the remote on by turning the remote’s key
clockwise to
position “1”.
To pair the remote to the receiver, press and hold the
green start button on the remote for a few seconds until
the green LED light on the remote flashes slowly. The
blue status LED light on the receiver (located inside the
electrical cabinet) will flash quickly indicating that it is
paired to the remote.
Drive the C60RX to the desired position using the left and right track controls on the remote.
For safety reasons, the feed roller is disabled while the
tracks are active. To reactivate the feed roller, the
remote must be disconnected from the machine.
To disconnect the remote without causing the safety
system to shut the engine down, the operator can
"acknowledge and allow" the remote to be safely
disconnected by holding down the silver button on the
receiver cabinet while switching off the remote
(by turni
ng the remote key to its “0” position).
2
3
4
Start button
(connects the
remote to the
chipper’s
receiver)
Remote key
(on/off switch for the remote)
Electrical
cabinet
Power LED
(green)
Status LED
(blue)