2
English
Assembly
(see page 4)
Safety Notes
Gloves should be worn during installation to prevent crushing and cutting
injuries.
Children as well as adults with physical, mental and/or sensoric impairments
must not use this product without proper supervision. Persons under the
influence of alcohol or drugs are prohibited from using this product.
The product may only be used for bathing, hygienic and body cleaning
purposes.
Do not allow the streams of the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between the shower and you.
The product may not be used as a holding handle. A separate handle must be
installed.
The hot and cold supplies must be of equal pressures.
Installation Instructions
• Prior to installation, inspect the product for transport damages. After it has been
installed, no transport or surface damage will be honoured.
• The pipes and the fixture must be installed, flushed and tested as per the
applicable standards.
• The plumbing codes applicable in the respective countries must be observed.
• The mesh washer must be insert to protect the shower against incoming dirt by
pipework. Incoming dirt leads to defects or/and can damage parts of the
shower; such caused faults voids all liability and guarantee claims.
Technical Data
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 70°C
Recommended hot water temp.:
65°C
Thermal disinfection:
max. 70°C / 4 min
• Safety against backflow
• The product is exclusively designed for drinking water!
Symbol description
Do not use silicone containing acetic acid!
Maintenance
(see page 7)
The check valves must be checked regularly according to EN 806-5 in accord-
ance with national or regional regulations (at least once a year).
Hot and cold supplies are reversed (see page 6)
Dimensions
(see page 5)
Flow diagram
(see page 5)
Hand shower
Bath Spout
Spare parts
(see page 9)
Special accessories
(order as an extra)
extension 60 mm #93882000 (see page 9)
Cleaning
(see page 8)
Operation
(see page 7)
Fault
Cause
Remedy
Insufficient water
- Shower filter seal dirty
- Clean filter seal between shower and hose
Mixer stiff
- Cartridge defective, calcified
- Exchange cartridge
Mixer dripping
- Cartridge defective
- Exchange cartridge
Spout temperature does not correspond with
temperature set
- Hot and cold supplies are reversed
- Install function block turned through 180º
(see page 6)
Instantaneous heater didn’t work
- Shower filter seal dirty
- Clean filter seal between shower and hose
- Flow limiter in handshower isn’t removed
- Remove flow limiter
