0 4
S A F E T Y N O T E S
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The product may only be used for bathing, hygienic
and body cleaning purposes.
The hot and cold supplies must be of equal pressures.
I N S T A L L A T I O N I N S T R U C T I O N S
⁄ Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
⁄ The pipes and the fixture must be installed, flushed and
tested as per the applicable standards.
⁄ The plumbing codes applicable in the respective coun-
tries must be observed.
⁄ If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
®
(flow limiter) located behind the aerator can be
removed.
⁄ The drain valve must only be used as intended. It is not
allowed to attach other objects to the drain valve, for
example a semi-pedestal.
T E C H N I C A L D A T A
This mixer series-produced with EcoSmart
®
(flow limiter)
Operating pressure:
max. 1 MPa
Recommended operating pressure:
0,1 - 0,5 MPa
Test pressure:
1,6 MPa
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
max. 70°C
Recommended hot water temp.:
65°C
Thermal disinfection:
max. 70°C ⁄ 4 min
The product is exclusively designed for drinking water!
⁄ special tool #58085000
(see page 31)
⁄ Installation putty
(see page 32)
S P E C I A L A C C E S S O R I E S
(order as an extra)
F L O W D I A G R A M
(see page 34)
with EcoSmart
®
without EcoSmart
®
A S S E M B L Y (see page 31)
O P E R A T I O N
(see page 36)
Hansgrohe recommends not to use as drinking
water the first half liter of water drawn in the
morning or after a prolonged period of non-use.
C L E A N I N G
see enclosed brochure
S P A R E P A R T S
(see page 35)
Do not use silicone containing acetic acid!
S Y M B O L D E S C R I P T I O N
D I M E N S I O N S
(see page 34)
EN
T E S T C E R T I F I C A T E
(see page 33)
