ACL00108
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE WARRANTY CLAIMS PLEASE KEEP INSTRUCTION SHEET, WARRANTY CARD AND COPY OF RECEIPT
Page 2
Step 1:
Do not attempt assembly if any parts are missing or damaged.
Step 2:
Hand tighten only.
Hand tighten only.
Hand tighten only.
Step 3:
Do not over tighten
Step 4:
Remove all protective materials and set parts on a flat, non-abrasive surface. Identify parts packed in carton against the
parts list. If you are missing any parts or are unsure how to proceed with assembly, call our Customer Service Center
at 1-800-416-3511.
Place the ottoman top upside down on a flat, non-abrasive surface. Attach a ottoman leg-1 to the ottoman top by using
two bolts and washers as shown in
. Guide the bolt through the hole in the leg-1, into the pre-drilled hole in
the table rim.
Repeat for the other leg-1. Attach a ottoman leg-2 to the ottoman top by using three
bolts and washers as shown in
.
Repeat for the other leg-2. Attach a ottoman leg-3 to the
ottoman top by using three bolts and washers as shown in
.
After making any necessary adjustments to the alignment of the legs and the ottoman top bracket, use hex bolt driver to
tighten all bolts.
. Over tightening may strip bolts or damage the welds or frame. Cover all bolts
with covers.
At the time, turn the table in the upright position. Your ottoman is now ready for use. If you have any questions, please
call our Customer Service Center at 1-800-416-3511.
Figure 1
Figure 2
Figure 3
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or improper assembly is not
covered under our warranty. Please read all instructions carefully before assembly. If you have any questions regarding
your assembly, call our Customer Service Center at 1-800-416-3511.
PARTS LIST
ORDER PART #
DESCRIPTION
BOLT COVER
HEX BOLT DRIVER
1/4" X 18 MM BOLT
OTTOMAN TOP
QTY
1
12
1
1
12
12
2
A
B
C
D
E
F
G
H
HW0105
HW0004
HW0035
HW0006
FOOT CAP
FACTORY ASSEMBLY
* NOTE: PARTS SHOWN ON PARTS LIST ARE NOT TO SCALE
6.5 X 1.0 MM
WASHER
Ø
FC0030
OTTOMAN LEG-1
2
F
H
G
D
Figure 3
F
H
G
Figure 2
C
H
F
G
A
B
F
H
G
FOOT CAP
Figure 1
OTTOMAN LEG-2
OTTOMAN LEG-3
