SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
Instruction Manual
www.hannainst.com
Dear Customer,
Thank you for choosing a Hanna Product. Please read the
instructions carefully before using the chemical test kit. It
will provide you with the necessary information for correct
use of the kit.
Remove the chemical test kit from the packing material and
examine it carefully to make sure that no damage has
occurred during shipping. If there is any noticeable dam-
age, notify your Dealer or the nearest Hanna office
immediately.
Each kit is supplied with:
• HI 3847-0 Reagent, packets (100 pcs);
• 1 color comparator cube.
Note:
Any damaged or defective item must be returned in
its original packing materials.
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
HI 3847
Copper
Test Kit
ISTR3847 03/99 PRINTED IN ITALY
Range
0 to 2.5 ppm
Smallest Increment
0.5 ppm
Analysis Method
Colorimetric, bicinchoninate
Sample Size
5 mL
Number of Tests
100
Case Dimensions
230x59x70 mm (9.0x2.3x2.8")
Shipping Weight
150 g (5.3 oz.)
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
SIGNIFICANCE AND USE
CHEMICAL REACTION
CHEMICAL REACTION
CHEMICAL REACTION
CHEMICAL REACTION
CHEMICAL REACTION
Copper salts react with bicinchoninate reagent to form a
purple product in a neutral buffered condition. The amount
of color developed is proportional to the concentration of
copper present in the aqueous sample.
Copper is an essential trace element in human diet (the
daily requirement is around 2.0 mg) and a factor in plant
metabolism. Copper salts are used in water supply systems
to control biological growth in reservoirs. Corrosion of copper
alloys in pipe fittings on the other hand may introduce
considerable quantities into the water supplies.
Note:
mg/L is equivalent to ppm (parts per million).
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
INSTRUCTIONS
READ THE ENTIRE INSTRUCTIONS BEFORE USING THE KIT
• Fill one color comparator cube with 5 mL of the sample
(to the mark).
• Add 1 packet of HI 3847-0, replace the cap and shake
well.
• Wait 45 seconds to allow color to develop.
• Determine which color matches the solution in the vessel
and record the result in mg/L (or ppm) of Copper.
REFERENCES
REFERENCES
REFERENCES
REFERENCES
REFERENCES
Adaptation of EPA approved method.
HEALTH AND SAFETY
HEALTH AND SAFETY
HEALTH AND SAFETY
HEALTH AND SAFETY
HEALTH AND SAFETY
The chemicals contained in this test kit may be hazardous if
improperly handled. Read Health and Safety Data Sheets
before performing the test.
• It is better to match the color with a white sheet at
about 10 cm behind the comparator.
Note:
To measure Copper in the 0-0.25 ppm range, use
the
HI 3856
Copper Ultra Low Range Test Kit.
