13
Available functions
with search-index (a-i)
a) Resetting of the stop watch
b) Changing the MODE (function)
c) Measurement of time periods
d) Event-Counter
e) Pre-setting of the Split-Time
f) Memory Recall with Quick Recall and evaluation
g) Countdown
h) Pacer E 200
i) Setting of the time, date, CD, Pacer and measuring units
a) Resetting the watch
By pressing the START/STOP and MODE keys at the same time, all
times and values are erased from the memory. Date and Time of Day
remain in memory. The display in the function window then shows
LAP.
b) MODE
(Changing functions):
By pressing the MODE key, the functions will be changed in the
versions indicated in the following sequences:
E 200
LAP
➤
S-LAP
➤
TIME
➤
DATE
➤
CD
➤
PACER
and back to LAP
Spectron LAP
➤
S-LAP
➤
TIME
➤
DATE
➤
CD
➤
empty
and back to LAP
The active function is indicated in the function window. The times and
values corresponding to these functions are shown in the upper row
of the display, as follows:
LAP:
Lap Time
6 digits
S-LAP:
Lap or Short Time
6 digits
TIME:
Time of day:
23:45,59
DATE:
Date (Europe)
01.01.08 (01. Jan. 2008)
(USA)
01.01.08 (01. Jan. 2008)
14
Additionally for DELTA E 200
PACER:
signals/min
3 digits
50 ms accuracy
CD:
Countdown
5 digits
1/10 sec-accuracy
Additionally for SPECTRON:
CD:
Countdown
5 digits
1/10 sec-accuracy
LEER:
Switch
min/sec
Normally, the Split Time is shown in the lower row of the display.
A note on LAP, S-LAP und TIME
Once the watch has been started and the time is being measured, a
selection can be made only from among these three functions.
A note on Countdown
After a start, it is not possible to change the Mode. However, virtually
the same time measurement can be completed with START/STOP and
SPLIT/LAP (see CD function).
A note on PACER
After a start, it is not possible to change the Mode. However, the total
time is measured and the START/STOP function remains operative
(see Pacer function).
c) Measuring times
- Select the one of the function LAP, S-LAP or TIME by means of the
MODE key.
- The stopwatch starts by means of the START/STOP key. Time measu-
rement begins and is visible while in operation. The figure
(a running man) indicates this condition.
By pressing the START/STOP key again, Split Time and Countdown
stop. This sequence can be repeated as often as desired.
- By pressing the SPLIT/LAP key, the Split Time and Lap Time values
will be stored in memory at that moment.
