7
4 Appearance
Paper Case
Paper slot out
Power button
Power indicator
Mode indicator
Error indicator
Feed button
RS232 connection
Power port
USB connection
5 Preparation before
5.1 Using Preparation
5.1.1 Battery Installation
1
．
Put the battery into the battery slot.
2
．
Cover with the battery case.
5.1.2 Paper Installation
1
．
Power on the printer.
2
．
Put the hand on both side of the paper case cover and open it.
3. Put a new paper roll.
4
．
Tear the paper head to make it like an arrow, then insert the paper into the paper in
slot, the printer will feed the paper automatically. If the paper feed not enough, then
manually press the FEED button, till the paper head comes out a bit from the paper out
slot.
5
．
Close the paper case cover and tear off the redundant paper.
5.2 Basic Operation
5.2.1 Power On
Don’t release Power button about 1 second until the printer beeps 1 time, and MODE
indicator lights on, then the printer is powered on, BATTERY indicator shows the battery
power volume.
5.2.2 Power Off
Under power on status, don’t release Power button about 1 second until the printer
beeps 2 times, and MODE indicator lights off, then the printer is powered off.
5.2.3 Paper Feeding (Manual Feeding)
Under the normal work status, press
【
FEED
】
button, the paper feeding begins, and
stop when loosen
【
FEED
】
button. When the printer apply to black mark paper, press
【
FEED
】
button, the printer begins to feed paper and stops over the position of black
mark. If the paper is not the black mark paper, the printer stops automatically after feeds
paper for 30cm.