29
5. Safety Instructions
1.
Only trained and authorized operator shall
be permitted to operate the truck.
2.
Inspect the truck at periodic intervals for
oil or water leak, deformation, lousiness, etc. If
neglected, short life of components will be
caused and in the worst case a fatal accident
would occur.
–
Make sure having replaced good parts
during periodic check.
–
Wipe off oil, grease or water from the floor
board and foot and hand controls, if any.
–
Strictly prohibit smoking and spark nearby
the storage battery when checking it.
–
If maintenance on high position, such as
mast, front and rear lamp, please be
careful to prevent fall down or be
clamped.
–
Be careful do not be scalded when
inspect the motor, controller and etc.
3.
whatsoever in trouble, you must stop the
forklift, hang a mark of “danger” or “trouble”
and take off the key, at the same time inform
the manager. Only after the trouble is removed,
you may use the forklift.
–
If trouble occurs when lifting cargo, to
Climb or descend, or the storage battery
electrolyte, the hydraulic fluid, the brake
fluid has the revelation, please organizes
the personnel to repair immediately.
4.
Operator must wear helmet, safety shoes
and work clothes.
5.
Because there will bring exploding gas in
the bosom of the battery, prohibit any flame
nearby it absolutely.
–
Do not let any tools close the two terminal
of the battery to avoid spark or short
circuit.
6.
The movement road of forklift should be
solid and smooth coagulation road or similar to
the road suitable for vehicle. Recheck the state
of working ground.
–
The considered climatic conditions when
the forklift designs are: Temperature -
20
℃
-50
℃
; the wind speed does not
surpass 5m/s; the air relative humidity is
not bigger than 90% (temperature 20
℃
).
–
The forklift is not suitable in the flammable
explosive working conditions.
–
Altitude: No more than 2000 meters.
7.
Never mount or dismount the moving
truck. Use the safety step(s) and safety grip
facing the truck when mounting or dismounting
the truck.
