27
3) Clean oil tuck then install.
4) Take out the dipstick.Add hydraulic
oil.See <<Table for the oil used in the
truck>>.
5) Startup engine.
6) Step on the brake pedal,operate the
engine,let the transmission at state of go
forward and backpedal so that the oil is
in clutch.
7) Let the transmission at neutral,strain
hand brake.
8) Take out the dipstick,inspect fluid
position.
9) If oil is not enough,add oil to keep it
between max and mix graduation.
10) Check the filter and oil tuck if
leakage.
11) Flameout engine,install front
soleplate.
6. Air-bleeding fuel system Diesel
During add fuel or discharge water
from sedimentor, it’s also need to bleed
air in the fuel system.
①
Loosen the bleed plug
②
press the priming pump until fuel
coming through the bleed plug contains
no bubble.
Fasten the bleed plug.
③
7. Water discharge from sedimentor
(W10
、
W15A
、
W32
、
W33Diesel truck.)
When the sedimentor indicator
lamp lights up, it means need water
discharge.
Put a container under the fuel filter
①
。
Loosen away the drain bolt
②
（
W15A
）
,
then loosen the drain plug by turning 4
to 5 turns to dewater.
Fasten the drain bolt
③
（
W15A
）
and
plug after the water was discharged.
8 Exhaust gas check
Colorless
Normal: complete
combustion
Black
Abnormal: incomplete
combustion
White
Abnormal: water come in
the burnt house
Blue
Abnormal: oil burns
Warning!
Don’t start the lift truck in bad
ventilation space. There is carbon
monoxide in the exhaust gas, it is very
dangerous.
Maintain semiannually (1000 hours)
Increase the below content base on
maintain monthly.
1. Brake oil fluid change
1) Let the truck at level ground,
play-down the fork to floor, inclined
back the mast, strain brake handle. When
transmission is at neutral position,
engine is cutoff.
2) Pick off the rubber dustproof cap of oil
orifice, install the both sides of
preliminary clarity tube to oil orifice and
