HANGCHA CBD20-AMC1, Operation And Maintenance Manua

Page: 59 / 71

55
WARNING
No broken wire sheath, or else the circuit might be damaged.
Do not process the locating surface or the holes of the production without
authorization, or else the magnet loop would be influenced.
Do not over press when fitting the motor shaft. Make sure no damage on the friction
surface and wipe off the burr of the mounting holes and surfaces. Put the shaft
sleeve on the motor shaft and fasten the axial clamp spring.
Measure the direct voltage of the connecting brake and compare the value to the
rated voltage on the nameplate. Deviation should not be more than 10%.
Make sure it is free from oil and dirt when installing and using the brake.
1.5.3 Maintenance
If work in high temperature environment for long time, please prevent rust, it may influence
use if there is rust on the suction surface.
Do not touch the friction surface with hand, no oil stain, otherwise it cannot reach the
maximum torque.
General use environment temperature is -10 +40 .
Please check periodically, and the check item : if the switch motion is normal; if there is noise;
if there is abnormal heating; if any impurity, oil stain mixed into friction part or rotating part; if
clearance of friction part is proper, exciting voltage normal.
OIL
U=x V DC±10%