29
Hangar 9 Toledo Special Assembly Manual
Step 16
Slide a clevis retainer on a clevis, then thread the clevis
on the pushrod wire. With the radio system on to keep the
aileron servo centered, thread the clevis in or out so the
aileron aligns with the trailing edge of the wing. Connect the
clevis to the center hole of the aileron control horn then slide
the clevis retainer on the clevis to keep it secure.
Step 17
Repeat Steps 1 through 16 to install the aileron servo in the
opposite wing panel.
Wing Installation
Required Parts
Wing bolt plate
Fuselage assembly
Nylon wing bolt (2)
Wing panel assembly (right and left)
Anodized aluminum wing tube
Anodized aluminum anti-rotation tube
Step 1
Locate the items necessary to mount the wing to the
fuselage. Most items are in the bag marked wing. The wing
tubes are unmarked, but the bag contains only the anodized
wing tube and the anodized anti-rotation tube. A small flat
screwdriver can be used to remove obstructions.
Step 2
Slide the anodized wing tube and the anodized anti-rotation
tube into one of the wing panels. The tubes will slide in
easily. If not, look for obstructions in the wing tube.
Step 3
Slide the remaining wing panel on the tubes. The two wing
panels will fit tightly together.
Step 4
Position the wing over the fuselage. Plug the servo
extensions from the aileron servos into the Y-harness or
servo extensions that were plugged into the receiver when it
was installed earlier.
