MAINTENANCE AND TROUBLESHOOTING
-
Ⅳ
-
§4.2Welding operation
:
Main Start-up Interface (POWER MIG 200 LCD):
1
. Function selection interface:
rotate L Knob in the interface to choose from the four
welding methods of MIG/MAG Synergic, MIG/MAG Manual, Stick and TIG Lift.
2
. Synergic parameter selection interface:
a synergic parameter may be selected by
rotating L Knob in the interface.
3
. Welding parameter setting interface:
a welding parameter and its corresponding value
may be selected and set by rotating L Knob and R Knob in the interface.
4
. System setting interface:
a system parameter and its corresponding value may be
selected and set by rotating L Knob and R Knob in the interface shown below:
System parameters
available by rotating L
Knob
System parameters
available by rotating R
Knob
Language
English/Simplified
Chinese...
Unit
English/Metric
Beeper On/off
Brightness
1 - 10
Factory Reset
Press