Handlink WG-500P 24Roam, User Manual

Page: 8 / 91

WG-500P Hotspot in a Printer

WLAN LED:
Off: The wireless is not ready.
Green light: The WG-500P 24Roam has established a valid wireless
connection.
Green Blinking: The wireless connection is active.

UPLINK LED:
Off: A port has not established any network connection.
Yellow light: A port has established a valid 10/100 Mbps network connection.
Yellow Blinking: 10/100 Mbps traffic is traversing the port.

Reset Button:
The WG-500P 24Roam has a reset button at the rear panel of the device. Use
this function to reset the system back to factory defaults.

Power Jack:
Used to connect the external power adaptor with WG-500P 24Roam.
1-4-1 Printing a test page
After you have installed your printer, you should print a test page to make sure the
printer is functioning properly. To do this act as follows:
1.
Turn the printer off.
2. Hold down the button A for approximately five seconds, and then turn the printer
on.
3. The printer will print a test page.
7