MINIVATOR SIM INSTALLATION MANUAL
7
E
N
G
L
IS
H
Figure 14
Figure 13
Figure 15
Track assembly
10
If the power supply is:
a
At the top of the track:
• Feed the long power cable with the push
terminals from the power supply through
the large cavity in the assembled track.
b
At the bottom of the track:
• Bring the long power cable with the push
terminals from the power supply to the
bottom of the track.
11
Slide the track up the stairs and position it
centrally to give you sufficient room to work
comfortably at the bottom of the stairs.
12
Connect the positive push terminal (white
cable) to the red push terminal attached to
the busbar
(Figure 13)
.
13
Connect the negative push terminal (black
cable) to the push terminal from the track.
14
Fit the bottom end stop and final limit stop
to the bottom of the track only
(Figure 14)
.
Do not tighten the grub screws at this time.
15
Fit the bottom end cap to the track
(Figure 15)
, ensuring that the power supply
cable is fed through the channel provided so
that it exits the track on the WALL side.
16
Tighten the grub screws to secure the end
cap to the track.
17
Now slide the bottom end stop and final limit
stop so that they sit against the positioning
extensions of the end cap and then tighten
the grub screws
(Figure 15)
.
Note:
The grub screws on the end cap should
not be over tightened.
Note:
The shorter (square ended stop) must
be fitted in the top channel – failure to do
this correctly could damage the lift.
05029 Sim Install MULTI ENG:Layout 1 17/06/2010 14:47 Page 7
