Handicare Raptor, Service Manual, Page: 92 / 163

PG
DRIVES TECHNOLOGY
61
E
GIS
- W
ARNING
S
UMMARY
SK75326/6
2.11 Connections - General
The scooter manufacturer is responsible for establishing
the suitability of the particular wiring arrangements used
on the scooter, for both normal use and stalled conditions.
PGDT can make general recommendations for wiring for
Egis Scooter Controller, but PGDT accepts no responsibility
for, and accepts no liability for losses of any kind arising
from, the actual wiring arrangement used.
The scooter manufacturer is responsible for ensuring that
only the mating connectors specified by PGDT on the control
system’s specific data sheet are used to connect to the
controller. PGDT accepts no liability for losses of any kind
arising from failure to comply with this condition.
The scooter manufacturer is responsible for ensuring that
suitable connectors are used and securely mated throughout
the scooter wiring system and that the workmanship
associated with the wiring system is of a good enough quality.
Failure to meet this condition could result in intermittent
operation, sudden stopping or veering, or even create a burn
or fire hazard. PGDT accepts no liability for losses of any
kind arising from failure to comply with this condition.
Defective or poor quality crimps may affect the warranty of
the controller. PGDT accepts no liability for losses of any
kind arising from failure to comply with this condition. Chapter
2 Section 3.1
2.12 Battery Connections
The scooter manufacturer must install a suitable circuit
breaker to provide protection against short circuits in the
battery wiring, power loom or the control system. Failure to
comply with this could result in a fire hazard. PGDT accepts
no liability for losses of any kind arising from failure to
comply with this condition. Chapter 2 Section 3.2
2.13 Freewheel
If you have disengaged the brake and the scooter is switched
off, then it may be possible for the scooter to freewheel at