Handicare Raptor, Service Manual, Page: 68 / 163

PG
DRIVES TECHNOLOGY
37
E
GIS
- I
NSTALLATION
SK75326/6
9 Production Tests
Perform the following tests, in order, on each scooter before dispatch.
These tests should be conducted in an open space and a
restraining device such as a seat belt should always be
used. PGDT accepts no liability for losses of any kind arising
from failure to comply with this condition.
9.1 Mounting
Make sure that the controller is securely mounted. Do not overtighten any securing
screws.
9.2 Cables and Connectors
Check all cables and connectors for damage. Make sure that all connectors are
securely mated.
9.3 Preset Settings
Make sure that the controller is using the preset settings. Refer to the Programming
and Diagnostic Manual for detailed instructions.
Controllers are always supplied with the settings shown on the relevant data sheet.
9.4 Operational Test
This test should be carried out on a level floor with at least one meter clear space
around the scooter.
• Switch on the scooter.
• Check that the status indicator remains on, or flashes slowly, after half a
second.
• Go to drive the scooter slowly in the forwards direction until you hear the
solenoid brake operate. The scooter may start to move.
• Immediately release the throttle. You must be able to hear the solenoid brake
operate within a few seconds.
• Repeat the test in the reverse direction.
9.5 Test Drive
Drive the scooter and make sure that it operates correctly for all positions of the user
controls.