Handicare Raptor, Service Manual, Page: 65 / 163

E
GIS
SK75326/6
PG
DRIVES TECHNOLOGY
34
7.1.2 Inhibit 1 Operation
The parameter can be set to one of two states:
Latched - Means the inhibitor, such as the charger plug, must be
removed and the controller turned off and on before the
scooter can be operated again.
Non-Latched - Means the controller can be reset to an operational state by
removing the inhibitor.
If set to Latched, then when Inhibit is active the TruCharge display will step-up to
indicate the scooter is charging.
Example - To provide a charge inhibit function that is active when Inhibit is connected
to 0V and is latching, program as below.
Mode = 1
Operation = Latched
If this inhibit is activated then the controller will cause the scooter to decelerate to a
complete stop (as if the throttle has been released).
3 3 3
EGIS INHIBIT LINE ACTIVE STATES
3
0V
Mode 1
Connected to 0V
3
0V
Mode 2
Open-circuit
3 3
0V
OR
0V
Mode 3
Connected to 0V or
Open-circuit
24V
Mode 4
Connected to
Bve
3
3
24V
OR
0V
Mode 5
Connected to
Bve or 0V
OR
24V
24V
Mode 6
Connected to Bve
or Open-circuit