Handicare Raptor, Service Manual, Page: 37 / 163

E
GIS
SK75326/6
PG
DRIVES TECHNOLOGY
6
4 Getting Ready to Drive
Check that the speed limiting control is turned to a position which suits you.
Operate the on/off switch. A TruCharge type status indicator will blink and turn on after
half a second. A single bulb (or LED) type status indicator will turn on immediately.
If the scooter has a single-ended throttle, use the reverse switch to select the direction
you want to drive and then push the throttle to control the speed. If the scooter has a
wig-wag throttle, push the throttle in the direction you want to drive.
During the first half-second after the scooter is switched
on, the controller is performing important safety checks
within itself and the rest of the scooter’s electrical system.
Therefore, if you push the throttle during this time, you will
not be able to drive until you have returned the throttle to
the rest position. This condition is indicated on a single bulb
(or LED) type status indicator by a rapid flashing, or on a
TruCharge type status indicator by a “rippling “ up and down
of the battery gauge.
If you do not push the throttle as you switch the scooter on and the status indicator
flashes rapidly, then there may be a fault. Refer to section 8.4 for details.
5 Tips for Using Your Controller
5.1 Driving - General
Make sure that all the controls are within easy reach and are comfortable to operate.
5.2 Driving Technique
The controller interprets the throttle movements and reverse switch setting (if fitted) and
drives the scooter in the correct direction at the appropriate speed. You will need very
little concentration to control the scooter, which is especially useful if you are
inexperienced.
The further you push the throttle away from the rest position, the faster the scooter will
go.
The intelligent speed control system minimizes the effects of slopes and different types
of terrain.
The scooter user must be capable of driving a scooter safely.
PGDT accepts no liability for losses of any kind arising
from failure to comply with this condition.