Handicare Raptor, Service Manual, Page: 139 / 163

SP1A
SK73762/6
PG
DRIVES TECHNOLOGY
34
The battery needs charging or there is a bad connection to the
battery. Check the connections to the battery. If the connections
are good, try charging the battery.
1 Bar
There is a bad connection to the motor. Check all connections
between the motor and the controller.
2 Bar
The motor has a short circuit to a battery connection.
Contact your service agent.
3 Bar
4 Bar
Not used.
5 Bar
The controller is being inhibited from driving, this may be
because the battery charger is connected or the seat is not in
the driving position. Check the controller voltage. Refer to 3.6.
6 Bar
A throttle trip is indicated. Make sure that the throttle is in the rest
position before switching on the scooter. Check the controller
voltage. Refer to 3.7.
7 Bar
A controller trip is indicated. Make sure that all connections are
secure. Contact your service agent.
8 Bar
9 Bar
An excessive voltage has been applied to the controller. This is
usually caused by a poor battery connection. Check the battery
connections. Check the controller voltage. Refer to 3.10.
10 Bar
3 Trip Types and Their Possible Causes
Once the trip type has been established, refer to the relevant section below for further
information.
The controller has entered sleep mode. Switch the scooter off
and on again.
Blink
The freewheel switch or manual brake disengagement
mechanism are operated. This is instigated only on systems
where there is a switch wired to the Egis’ Freewheel input.Check
the position of the switch. Refer to 3.4.
There is a bad connection to the parking brake. Some scooters
will register this error type when the freewheel lever is
disengaged. First of all, check the freewheel lever is in the drive
position, then check all connections between the parking brake
and the controller. Refer to 3.9.