Handicare Raptor, Service Manual, Page: 116 / 163

PG
DRIVES TECHNOLOGY
11
SP1A - P
ROGRAMMING
SK73762/6
Ensure the stability of the scooter is maintained, especially
when cornering, at the programmed Max Forward Speed.
4.6 Min Forward Speed ?
This sets the MINIMUM forward speed of the scooter.
For this parameter to operate, a Speed Limiting Potentiometer must be fitted and
correctly programmed. The Speed Limiting Potentiometer must be fitted in Parallel.
Under these conditions there are two available settings.
Fast This value is used when the scooter’s Speed Limiting
potentiometer is set to Slow and the Slow/Fast switch is set to Fast.
Slow This value is used when the scooter’s Speed Limiting
potentiometer is set to Slow and the Slow/Fast switch is set to
Slow.
The value is displayed as a percentage of the scooters total available output. Therefore
if the Fast value is set to 40% then the scooter will be able to drive at up to 40% of the
total available speed when the Slow/Fast switch is in the Fast position and the Speed
Limiting Potentiometer is in the Slow position.
If there is no Slow/Fast switch fitted then only the Fast
value will be relevant.
4.7 Max Reverse Speed ?
This sets the MAXIMUM reverse speed of the scooter.
So long as a Slow/Fast switch is fitted to the scooter then there are two available settings.
Fast This value is used when the slow/fast switch is set to fast.
Slow This value is used when the slow/fast switch is set to slow.
The value is displayed as a percentage of the scooters total available output. Therefore
if the Fast value is set to 60% then the scooter will be able to drive at up to 60% of the
total available speed when the Slow/Fast switch is in the Fast position.
If there is no Slow/Fast switch fitted then only the Fast
value will be relevant.
4.8 Min Reverse Speed ?
This sets the MINIMUM reverse speed of the scooter.
For this parameter to operate, a Speed Limiting Potentiometer must be fitted and
correctly programmed. The Speed Limiting Potentiometer must be fitted in Parallel,
refer to Chapter 2 section 4.2. Under these conditions there are two available settings.
Fast This value is used when the scooter’s Speed Limiting
potentiometer is set to Slow and the Slow/Fast switch is set to Fast.