Handicare Raptor, Service Manual, Page: 112 / 163

PG
DRIVES TECHNOLOGY
7
SP1A - P
ROGRAMMING
SK73762/6
3 Using The SP1a
Please read this guide carefully before using the SP1a Programmer.
Programming should only be conducted by competent
personnel with in-depth knowledge of PGDT electronic
controllers. Incorrect programming could result in an unsafe
set-up of a vehicle for a user. PGDT accept no liability for
losses of any kind if the programming of the controller is
altered from factory pre-set values.
3.1 Connection
The SP1a can be connected to the controller when the controller is either on or off. You
can also drive with the SP1a connected.
For safety reasons, accessing some critical parameters will
cause the controller to trip. This is intentional and the controller
can be simply reset by switching off then on again.
Different versions of the SP1a are fitted with different connectors.
D49371 programmers are designed to program Solo controllers, but can be used to
program Egis and S-Drive controllers by adding adaptor D50048.
D50048 PROGRAMMING CABLE
End View
Connection to
Egis & S-Drive
Connection to
D49371
End View
D50040 programmers are designed to program Egis and S-Drive controllers, but can
be used to program Solo controllers by adding adaptor D50257.
Earlier SP1a programmers are not configured to program
the additional parameters in the S-Drive or Egis controllers.
3.1.1 Programming
To program, simply connect the SP1a to the controller whilst it is turned on. If the SP1a
is showing diagnostic information, press the ENTER key and the SP1a will go into
D50257 PROGRAMMING CABLE
End View End View
Connection to
Solo
Connection to
D50040