Hand Held Products SCANTEAM 2070 BASE, Manual

Page: 25 / 132

2–1 Cordless System Manual
Introduction
Use this section to program the Cordless System to work with your terminal or
computer (host system).
This programming section contains the following menu selections:
•
Keyboard
•
Wand Emulation
Section 2 Quick Start & Interface Menu
•
Terminal Interface
•
Country Code
•
Reset Factory Settings and Status Check
•
Output Delays
All operating parameters are stored in non-volatile memory resident in the
Cordless System, where they are permanently retained in the event of a power
interruption. When you receive your Cordless System, certain operating
parameters have already been set. These are the factory defaults, indicated by
the symbol “
✱
” on the programming pages (beneath the default programming bar
code). Default Charts that list all the factory settings may be found near the end
of this System Manual.
A Programming Chart (found on the inside back cover of this manual) contains
alphanumeric bar codes for setting additional programming options, such as the
digits representing Symbology Message Length. The chart explains how and
when to use the alphanumeric bar codes.
A Sample Bar Codes page (located on the back cover of this manual) provides
bar code symbols you may scan to verify that your Cordless System has been
programmed correctly and is communicating with your host system.
•
Plug and Play
Note: After scanning the following menu selections, there will be a pause (up
to 20 seconds) while the Base unit processes and uploads the new menuing
information to its parameter tables:
Plug and Play Selections (on the next two pages)
Factory Default Settings: ALL Application Groups (last page, Section 2)
Application Work Group Selections (Section 4)
•
Power Settings