Hand Held Products SCANTEAM 2070 BASE, Manual

Page: 17 / 132

1–7 Cordless System Manual
➎
Program your Cordless System to work with your terminal or computer by
scanning the Terminal Setup Codes. Use the Supported Terminal list
(Pages 2–5 to 2–6) to scan your terminal’s Terminal ID.
With Plug and Play programming, you scan
only one bar code to program the
Cordless System to work with a designated interface, including any required
prefixes and suffixes.
➏
To determine if your Cordless System is set up correctly, scan one of the
sample bar codes on the back cover of this manual.
Setting Up and Connecting the Cordless System, continued
After your Cordless Scanner has been associated with its base unit:
Connecting More Scanners to the System
Up to nine Cordless Scanners may be associated with one base unit . Add more
Cordless Scanners to a base unit by following the steps shown below:
➊
Make sure the Cordless Scanner’s battery pack has been fully charged.
➋
Scan the Association Bar Code (the bar code label on the top of the base)
to link each scanner to the base.
The base stores a unique I.D. for each scanner (up to nine) to identify the scanner
during data communication. Two beeps followed by clicking, then a single beep
from the scanner indicates a “good” association. The base rejects a tenth
Cordless Scanner trying to link to its network, sending the scanner an error
command. (A rejected scanner beeps three times, indicating an unsuccessful
association.)
within a 50 foot (15.24 meter) radius of the base, in an open air environment
Note: When you associate more scanners with the base, you don’t have to
program your Cordless System to communicate with your terminal or computer
if you’ve already completed step 5, above.
Note: After association, if the battery pack is removed from the scanner and
replaced, the scanner automatically reassociates to the base if the base has
remained powered up. In this case, the scanner beeps when a charged battery
pack is installed, then beeps a second time after full association, about five to ten
seconds later.