User Manual RDx-AC-xxxDT-10.31
Page 3 of 13
www.hanbayinc.com | 1 800 315 4461
Rev.2021.9 [email protected]
Once the cable and cable gland are installed, connect the wires to the pins on the terminal block as
indicated here. Note: the cables seen in the image below will not be present in explosion-proof models.
Wiring for Non-Explosion Proof actuators
The actuator comes standard with a pre-
installed cable gland and a 10’ cable. Cut the cable to the length
required, then connect according to the following wire color schematic:
Wire color schematic for cable
Pin
Function
6
Already connected to power supply
(connect live wire to loose black cable with crimp connector, see p.4)
5
Already connected to power supply
(connect neutral wire to loose white cable with crimp connector, see p.4)
4
Output TTL2
3
Output TTL1
2
Input TTL2
1
Input TTL1
Colour
Function
Red (1)
Live 110-240 VAC (16 AWG)
Black (2)
Neutral 110-240 VAC (16 AWG)
Blue (3)
Ground (16 AWG)
Green (4)
Output TTL2 (20 AWG)
Grey (5)
Output TTL1 (20 AWG)
Yellow (6)
Signal Input TTL 2 (20 AWG)
Blue (7)
Signal Input TTL 1 (20 AWG)
Terminal
1 2 3 4 5 6
