®
appendix C
Router Table Handles
Page 1: ... appendix C Router Table Handles ...
Page 2: ... forks will be down Securely clamp the boards to the KATIE JIG System using 2 clamps Placement of these clamps should be done to best accommodate the boards CAUTION Make sure the clamps do not interfere with the router bits Prepare Router Table and Set Height of Bits For best results use two routers mounted in router table Determine height for dovetail bit 1 2 for guide tuning forks Base of router...
Page 3: ...k or spacer At least 1 16 of bearing must extend above base of router table Pattern bit depth Routing Pins and Tails Grasp the router table handles on the side opposite the board that you wish to route and slide the KATIE JIG System toward the bit Carefully route the areas between each of the guide tuning forks CAUTION DO NOT lift the KATIE JIG System while the router is running ...
