Item #1003 111 651
Model #HD39377
Use and Care Guide
LOW VOLTAGE FLOOD LIGHT
Part
Description
Quantity
A
Lens cover
1
B
50W Halogen T3 Bi-Pin Bulb
1
C
Body
1
D
Adjustment screw
1
E
Connector
1
F
Spike
1
PACKAGE CONTENTS
Assembly and Installation
1
Attaching and installing the light
2
Connecting the wires
WARNING:
Never push the fixture into the ground by the lamp body (C) or use a
hammer to insert the spike (F) into the ground.
WARNING: The wire connector (E) contacts have sharp edges for piercing the
main low voltage cable. To avoid injury, do not touch the metal contacts.
CAUTION: The wire from the low voltage power unit shall be 12-16 AWG type
underground low Energy Circuit Cable or SPT2W.
CAUTION: Safe for outdoor operation
WARNING: To reduce the risk of FIRE OR INJURY TO PERSONS:
WARNING: Turn off/unplug and allow to cool before replacing lamp.
WARNING: Lamp gets HOT quickly! Contact only switch/plug when turning on.
Do not touch hot lens, guard or enclosure.
WARNING: Keep the lamp away from materials that may burn.
WARNING: Do not touch the lamp at any time. Use a soft cloth. Oil from skin may
damage the lamp.
WARNING: Do not operate the luminaire fitting with a missing or damaged lens
or bulb protector.
IMPORTANT:
• Protect the wiring by routing it in close proximity to the light fitting, or next to a
building structure such as a house or deck.
• The landscape wire and connector can also be hidden under stone or buried
under grass at a maximum depth of 6” (15.24 cm).
• Do not submerge fixture in water.
□
Carefully remove the fixture from its protective packaging.
□
Remove the lens cover (A) by turning it counterclockwise.
□
Do not remove the lens from the lens cover.
□
Insert the bulb (B) into the bulb socket. Use a soft cloth, as oil from
skin may damage the lamp bulb.
□
Replace the lens cover (A) on the body (C) by turning it clockwise.
□
Adjust the fixture’s angle by loosening the adjustment screw (D) and
retightening it.
□
Ensure the lens points up
and never towards the ground.
WARNING: Risk of Electric Shock. Install all luminaires 10 ft. (3.05 m) or more
from a pool, spa or fountain.
WARNING: Install in accordance with all local codes and ordinances.
□
Place the wire connector (E) on opposite sides of the low
voltage cable (not included) where the fixture will be located.
□
Align and fit the main low voltage cable vertically to the slot of
the wire connector (E) as shown.
□
Press the wire connector (E) together until fully seated and
locked around the cable. Pre-set prongs will pierce the cable
insulation and establish contact. Turn on the power unit. If the
light fixture does not turn on, repeat the previous steps.
□
Once the clip-on connector (E) is in place, it is recommended
to wrap it with electrical tape for additional protection.
□
CAUTION BE CAREFUL! THE WIRE STABS ARE VERY SHARP!
□
After all fixtures are installed, turn on the transformer.
E
Only for use with low voltage power units with a maximum output rating of 15V,
300W per secondary.
FOR LANDSCAPE LIGHTING SYSTEMS ONLY. OUTDOOR USE ONLY. THE DEVICE IS
ACCEPTED AS A COMPONENT OF A LANDSCAPE LIGHTING SYSTEM WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR LOCAL
INSPECTION AUTHORITIES HAVING JURISDICTION.
ETL LISTED UNDER MODEL # U000-4275
Please read and save these instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
IMPORTANT SAFETY INSTRUCTIONS
Lighted lamp is HOT!
A
B
C
D
F
E
A
B
C
F
D
