7
HAMPTONBAY.com
Please contact 1-844-760-3644 for further assistance.
Care and Cleaning
Ƒ
Use a dry cloth to clean the doorbell and sensor.
Ƒ
Do not use cleaners or polishes.
Ƒ
Do not use any fluids on the doorbell or sensor.
Troubleshooting
Problem
Possible Cause
Solution
Doorbell does not
sound.
Ƒ
Push button battery is not
installed correctly.
Ƒ
Make sure batteries are installed according to the
diagram inside the push button.
Ƒ
Push button battery is
dead.
Ƒ
Check the charge of the push button battery and
replace if necessary.
Ƒ
Doorbell is not receiving
power.
Ƒ
Make sure the plug-in doorbell has power.
Ƒ
Push button and doorbell
are not synced.
Ƒ
Sync the push button and doorbell:
Ƒ
Press and hold the button on the doorbell until the
doorbell sounds a “Beep-Beep”.
Ƒ
Press the push button within 30 seconds. The
doorbell will sound a “Beep-Beep” tone to indicate
the push button is synced.
Ƒ
Press the push button to ensure operation.
Batteries seem
okay, but the
doorbell does
not work after
installation.
Ƒ
Doorbell or push button is
mounted on metal or near
metal studs.
Ƒ
Metal reduces transmission range. Use 1/4 in. to 1/2 in.
(6 to 13 mm) wood shims to move the doorbell or push
button away from the metal surface.
Ƒ
Doorbell is mounted near
a concrete floor or wall.
Ƒ
Concrete may reduce range. Move the doorbell away
from the concrete surface.
Ƒ
Doorbell and push button
are installed too far apart.
Ƒ
Locate the doorbell closer to the push button.
Doorbell sounds
when not intended
(false triggers).
Ƒ
Doorbell is receiving
interference from another
wireless device.
Ƒ
Reset the doorbell and push button:
Ƒ
Remove the push button batteries. Wait 30
seconds.
Ƒ
Press and hold the push button for 10 to 15 sec-
onds within 60 seconds after installing the battery
into the push button.
Ƒ
Press and hold the button on the doorbell until the
doorbell sounds a “Beep-Beep-Beep-Beep”.
Ƒ
To re-sync the push button and doorbell, press and
hold the button on the doorbell until the doorbell
sounds a “Beep-Beep”.
Ƒ
Press the push button within 30 seconds. The
doorbell will sound a “Beep-Beep” tone to indicate
the push button is synced.
Ƒ
Press the push button to ensure operation.
