3
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Pre-Installation
PLANNING INSTALLATION
Report any defects noticed immediately after unpacking the product prior to installation. Ensure the countertop is installed and finished
(using oil, oil-wax, varnish) before use. Follow the instructions contained in this manual to keep the warranty valid.
NOTE:
Immediately after unpacking, the countertop must be finished on both sides and all edges. It is very
important to properly coat the countertop with a high quality oil. Finish the counter top surface with particular
regard to all cutting edges and end edges, strictly to the manufacturers’ specifications concerning the oil, wax
oil, or varnish.
Keep the countertop flat in a fully supported position, away from direct heat and moisture and in the original packaging. This helps to avoid
excessive sanding and wood warpage.
Storing the countertop upright or on its edge, in conjunction with heat or moisture, can result in the countertop warping.
WARNING:
Wooden countertops should be used in an ambient temperature of 32°F - 75°F (18°C - 24°C) and
humidity of 40-60 %.
The following features are completely natural for wood:
□
Differences in color, grain, and will have some small knots.
□
Wood darkens with time.
□
Wood is splash proof but not waterproof and wood fibres may raise if they are exposed to water for a long time.
□
Wood absorbs moisture from the environment and gives it back, which can cause a change in its volume.
TO AVOID CRACKING AND SPLITTING OF WOOD:
□
The installation must allow the wood to move (expand/contract):
□
Do not glue the countertop down.
□
Keep a 1/8 in. gap at the wall.
□
Holes in the brackets or blocks must be oversized to allow the fastener to keep the top secure but allow the top to move.
□
Use a flexible sealant to secure your sink.
□
Protecting the underside is as important as protecting the top.
□
Seal the underside of the top with a water-resistant sealant.
□
Additional protection may be required above dishwashers.
□
Protect wood-to-wood joints.
□
Seal edges with a water-resistant sealant prior to connecting the joints.
□
Use mechanical fasteners to pull and hold joints together.
