Care and Cleaning
FCC statement
Troubleshooting
5
□
Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully.
□
To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box, and use a dry or
slightly dampened, clean cloth to wipe the exterior surface of the fixture.
Design Solutions International Inc.
Model: xxxxxx
Address: 5101 NW 21st Ave, Suite 520, Fort Lauderdale, FL 33309
Telephone: 800-388-6141
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to
operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
Problem
Possible Cause
Solution
The lights will not turn on.
The bulb is burned out.
Replace the light bulb.
The power is off.
Ensure the power supply is turned on.
There is a faulty switch.
Test or replace the switch.
There is a faulty wire connection.
Check the wiring.
USB port will not connect.
The USB port is damaged.
Discontinue use of the USB port.
The power is off.
Ensure the power supply is turned on.
The connecting line is damaged.
Replace the connecting line.
Wireless charging will not
charge.
The wireless charging is damaged.
Discontinue use of the wireless charging.
The power is off.
Ensure the power supply is turned on.
The phone is not align to the wireless charging.
Adjust the position of the phone.
The fuse blows, or the circuit
breaker trips, when the light
is turned on.
There are crossed wires, or the power wire is
grounding out.
Discontinue use of the lamp. Check the wire connections.
Contact a qualified electrician or call the Customer Care
Service Team at 1-855-HD-HAMPTON.
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
