HAMPTON BAY 1002 695 373, Use And Care Manual, Page: 6 / 9

6
Assembly
1
Attaching the legs and leg
connector
2
□
Place upper leg (B) in a cross-x pattern over the
lower leg (C).
NOTE: Do not tighten the bolts fully until all parts are
attached to the chair frame.
□
Attach the ball bearing mechanism (E) to the chair
legs (B & C) by inserting four hex bolts (AA) and
metal washers (CC).
□
Tighten all the bolts completely by using the hex
wrench (EE).
□
Rotate the 2 plates of the ball bearing mechanism
at a 45 angle, cover each bolt with the plastic bolt
caps (DD).
□
Attach the leg connector bracket (D) to the chair
legs (B & C) by inserting four hex bolts (BB) and
metal washers (CC).
□
Tighten all the bolts completely by using the hex
wrench (EE).
□
Cover each bolt with the plastic bolt caps (DD).
Attaching the ball bearing
mechanism and chair legs