Hammond XK-5, Owner'S Manual, Page: 17 / 170

17
Hook
-Up
CONNECTING THE LESLIE SWITCH CU-1
1. Insert the plug of the CU-1 to the “CU-1” jack of this key-
board.
It does not need any operation to enable it.
CONNECTING THE EXPRESSION PEDAL
‹
USING EXP-100F
CONNECTING THE CONTROLLERS
‹
USING EXP-50/20
L / MONO
LINE OUT
R CTRL 1 CTRL 2
PEDAL
EXP.
ONLY
EXP-100F NORM.
POLARITY
REV.
LESLIE 11 PIN
FOOT CONTROLLER
NORM.
POLARITY
REV.
UPPER
BANK KEY PATCH
PEDAL LOWER
L / MONO
LINE OUT
R CTRL 1 CTRL 2
PEDAL
EXP.
ONLY
XP-100F NORM.
POLARITY
REV.
LESLIE 11 PIN
FOOT CONTROLLER
NORM.
POLARITY
REV.
UPPER
BANK KEY PATCH
PEDAL LOWER UPPER
BANK KEY PATCH
PEDAL LOWER
1. Connect the EXP-100F to the “EXP. PEDAL” jack.
2. Set the CONTROL - EXP. SOURCE at “PEDAL” or
“BOTH” (P. 79 #4).
1. Make sure that the [POWER] of this keyboard is “O ff ”.
2. Connect the EXP-50/20 to the FOOT CTRL 1/2 either.
3. Set the [POLARITY] at “NORM”.
4. Switch on this keyboard.
5. Set the CONTROL - FOOT CTL - CTRL 1/2 MODE at
“EXPRESSION” (P. 78 #1).
6. Set the CONTROL - EXP. SOURCE at “PEDAL” or
“BOTH” (P. 79 #4).
Attaching the CU-1 (separately
purchased)