Hammond XK-3C, Owner'S Manual

Page: 82 / 126

*#1 :-%
Owner’s Manual
82
DEFAULT
In this mode, you can go back entirely or partially to the default setting as per shipped
from the factory.
To locate this mode:
Touch the [MENU/EXIT] button for the MENU display, select PAGE E by the [PAGE] button,
and then touch the [1] DEFAULT button.
To initialize each parameter, touch the [PARAM] button and then [4] OK.
1. ADJUST PRESET
Initializes the content of the Preset Key [B].
If the Drawbar Control mode is at “UPPER A
<
/B”, the content of [A
<
] is also initialized.
If you do this operation before you start a new setting, you can start from the fresh status.
2. PRESETS
Initializes the content of all Combination Presets.
3. GLOBAL
Initializes the Global Parameters such as Master tune or assignment of the Foot Switch.
4. LESLIE
Initializes the content of all Cabinets.
5. TONE WHEEL
Initializes the Custom Tonewheels.
6. ALL
Initializes all parameters of this keyboard.
If anything caused an unstable condition on this keyboard system, the trouble would be
cleared.
NOTE: You can also totally initialize your module by switching the Power ON while touching and
holding [REC/JUMP] button.
NOTE: The value of the Preset Key [B] set by this function is different from Default - Adjust Preset
(#1).
1 2 3
5 6 4