43
K2 M - Part 2/2
Maintenance
3.5.2
Replacing the drive belt
1
2
3
4
Fig. 35: Replacing the drive belt
1 Guard plate
2 Screws M6x10
3 Locking nut
4 Tightening screw
Tool:
●
Spanner 13 mm
●
Allen key 4 mm
1.
Tilt the saw to the approx. 30° position. Move the saw blade to the lower-
most position.
2.
Switch off the machine and secure it against being switched on again.
Remove the saw blade.
3.
Disconnect the machine from the mains power supply.
4.
Remove the front and rear cover plate.
maintenance work / Removing the cover plate’ on page 35
5.
Loosen the screw and remove the guard plate.
6.
Loosen locking nut.
7.
Loosen the tensioning screw and release the tension on the old drive belt.
8.
Remove the old drive belt.
9.
Hook the new drive belt into place:
First hook onto the saw shaft.
Pull the drive motor upwards.
Hook the drive belt on the drive motor.
10.
Tension drive belt.
Chapter 3.5.3 ‘Re-tensioning the drive belt’
11.
Place the guard plate and screw on.
Summary of Contents for K2 M
Page 55: ......
