38
Maintenance
5.
Lubricate height guides with normal machine grease.
Spread the grease with a brush onto the guide.
6.
Position the saw unit in the lowest and then the most uppermost position.
7.
Prepare the machine to operate.
Chapter 1.3.3 ‘Establish operational
3.4.4
Check dust extractor
Check dust extractor for any damage
1.
Switch off machine and dust extractor.
2.
Carry out a visual inspection of all extraction hoses.
3.
Check the condition of the whole extraction system.
4.
For machines with effectively connected potential-free contact to the extrac-
tion system control:
Switch machine on.
Check that the extraction system runs with the machine.
5.
On machines without extraction system control:
Switch on dust extractor.
Switch machine on.
6.
Perform a visual inspection of all machine parts.
🡆
If any damage is identified on the machine or of the components, then
these are to be fixed immediately.
Check the effectiveness of the dust extractor
1.
Measure air flow and air speed.
2.
The extraction performance must be sufficient to achieve the negative pres-
sure and air speed required at the connection point (see technical data or
layout).
3.4.5
Check safety devices (emergency stop)
Safety equipment must be checked every six months. The saw shaft with clamped
saw blade must be brought to a complete stop within 10 seconds. In the event of
any problems or malfunctions, please contact a member of Felder-Group service
centre.
Alternatively, machines without a separate feed motor or scoring
motor can be equipped with red
[Stop]
buttons instead of the
[Emergency Stop]
buttons.
If the machine is equipped with an
[emergency stop]
button, test the functionality
Carry out emergency stop test with all red
[Stop]
buttons on the machine.
1.
Prepare the machine to operate.
2.
Switch machine on.
Summary of Contents for K2 M
Page 55: ......
