Hammer K2 M, Translation Of The Original Operating Instructions

Page: 37 / 56

37
K2 M - Part 2/2 Maintenance
2. Clean the machine of dust, shavings, waste material and other contami-
nants.
3. Cleaning the table surface and the guide tracks. Remove any resin residue.
4. Clean rip fence inc. guiding shaft and check that they work properly.
5. Carry out a visual check of all machine components.
🡆
If any damage is identified on the machine or of the components, then
these are to be fixed immediately.
6. Switch machine on.
3.4.2 Belt tension
The belt tension is factory set to the ideal value.
In time, the belt can stretch, causing the power transmissi-on to deteriorate. The
belt tension must be corrected in such a case.
⮫
Chapter 3.5.3 ‘Re-tensioning the
drive belt’ on page 44
If rips or tears are discovered during the monthly inspection, the belt must be
replaced immediately.
3.4.3 Lubricate the height guide of the circular saw unit
1
2
Fig. 31: Lubricate the height guide
1 Height guide
2 Insert board
Material:
● Machine Grease
1. Switch off the machine and secure it against being switched on again.
2. Preparing the machine for a tool change.
⮫
Chapter 1.3.2 ‘Prepare to
change tooling’ on page 11
3. Remove insert board and saw blade.
4. Thoroughly clean the height guide from chips, dust and grease residues.