60
Maintenance
1
2
Fig. 43: Lubricating nipple X-axis ball screw drive left side
1 Slot
2 Lubricating nipple X-axis
2.
Position the portal in such a way that the lubrication nipple on the left side is
in the recess.
CAUTION! Open, rotating drive spindles. Do not reach into the area of the
open spindle covers.
3.
Switch off the machine at the main switch, disconnect the power supply.
4.
Remove dirt or grease.
5.
Clean all lubricating nipples.
6.
Place the pressure grease gun onto the nipple and pump 3 times.
🡆
A small amount of lubrication will come out of the seals.
7.
Lubricate all (2) lubricating nipples.
8.
Attach cover.
9.
Switch machine on.
10.
Move several times over the entire length of the axle to distribute the grease.
🡆
Axis is covered with a thin film of grease.
X Axis: Lubricate guiding carriage
Both of the lubrication nipples are located under the side cover. Both X axes
guiding carriages have two lubricating nipples.
Personnel:
●
Trained machine operator
Protective equipment:
●
Protective clothing
●
Protective gloves
Summary of Contents for HNC3 825
Page 78: ...78 Disposal...
Page 79: ......
