40
!
"
#
&
&
!
"
#
$
%
$
%
Saw-Spindle Moulder
B3 / B3 e-classic
Making adjustments and preparations
Fig. 8-5: Adjusting the crosscut fence
Pivoting:
1.
Loosen the clamping lever and thumb screws.
2.
Pivot the crosscut fence to the desired position. Fold
the end stop back if necessary, so as to be able to
pivot the crosscut fence over it.
3.
Clamp the clamping lever in place and tighten the
thumb screws.
4.
Loosen the thumb screws, move the fence profile and
retighten the thumb screws in order to compensate
the length of the scale when the fence is pivoted.
!
Clamping lever
"
Crosscut fence
#
End stop
$
Outrigger
%
Locking plate
&
Thumb screws
90°-Position:
1.
Loosen the clamping lever and thumb screws.
2.
Pivot the crosscut fence, until it stops against the end
stop.
3.
Clamp the clamping lever in place and tighten the
thumb screws.
8.5 Cross stop
Fig. 8-6: Cross stop
The cross stop can be pushed onto the crosscut fence in
one movement.
If required, the end stop can be folded back.
1.
Loosen the thumb screw.
2.
Move the cross stop to the desired position. The
measurement (rip capacity) reading is read from the
magnifying lens.
3.
Tighten the thumb screw.
!
Thumb screws
"
Cross stop
#
Scale
$
End stop
%
Crosscut fence
