58
!
"
#
#
Saw-Spindle Moulder
B3 / B3 e-classic
Note: It is recommended to use safety bar guides (Accessories) when moulding profiles. An end-to-end work-
piece support (increased safety) and better results are achieved.
9.4.4 Safety bar guides
Fig. 9-7: Safety bar guides
Assembly/Disassembling:
See separate Assembly instructions „Safety bar guides“.
Sliding:
1.
Switch the machine off and ensure that it cannot be
switched on again.
2.
Loosen the clamping screws.
3.
Slide the safety bar guide upwards.
4.
Tighten the clamping screws.
5.
Check whether the spindle moulder tool is running
freely. The spindle moulder tool must not touch the
safety bar guides.
6.
Check whether the guides are parallel to the machi-
ne table.
!
Clamping screws
"
Safety bar guides
#
Guide
Fig. 9-8: Power feeder
Assembling:
To attach the power feeder, mount a tilting device on
the machine.
Adjusting:
See operating manual: „Power feeder“.
9.5 Power feeder
Making adjustments and preparations
