61
A2-26
Use
6.
Ensure that your hands are placed on the workpiece in a closed position
with the thumbs against the closed hands.
Requirements of the workpiece
To obtain exact joints, use only evenly grown wood without any
knots.
9.3.3
Planing of smaller workpieces
1
2
3
Fig. 46: Planing - Processing of smaller workpieces
1 Push block
2 Pushing grip
3 Auxiliary fence (W = min. 60 mm)
WARNING
Serious hand injuries due to insufficient preparation
Contact with the rotating cutterblock
−
Use a push block and pushing grip
−
Use an auxiliary fence that has a width of at least 60 mm
Protective equipment:
●
Push stick, push grip
1.
Take note of general procedures for permitted working methods.
9.2.5 ‘Work process with permitted working methods’ on page 58
2.
Adjust the cutterblock protective guard.
3.
Push the workpiece under the protective guard using the pushing stick and
push block. The pushing stick should not be thicker than the workpiece.
4.
Move the workpiece back over the protective guard into the starting posi-
tion.
