Hammar LIFEBUOY Replacement Manual Download Page 1

Page: 1 / 2

10-05

HAMMAR LIFEBUOY RELEASE SYSTEM

REPLACEMENT MANUAL

Specification:

• One ERU

• One release cord

• One pilot line for loading the lifebuoy

• One replacement manual

• One marking instruction

Replacement:

1. Secure the lifebuoy with a cord. This is a good opportunity to test the lifebuoy function by activating

the Release Switch or pulling the manual safety pin.

2. Dismount the ERU – use fixed spanner size 8. Discard the used ERU

in an environmentally approved manner. Make sure that the new ERU

is correctly marked before installation. Mount the new ERU – do not

tighten the nuts!

3. Unscrew the locking screw for the release screw and remove the old release cord. Mount the new

release cord. The ends of the release cord can be locked during installation by pulling the cord ends

into the V-slot. Make sure that the length of the cord is 20cm and that the cord will be well locked by

the washer before you tighten the locking screw again.

Summary of Contents for LIFEBUOY

Page 2: ...e release cord through the H20ERU release unit Make sure that the lifebuoy line is not on the outward side of the release cord 5 Pull up the release cord through the ERU hole with the pilot line Secure it with the manual safety pin 6 Connect the ERU cable at the connector box 7 The system is now ready to be used The ERU shall be changed after two years of service ...