4 Installation of Wi-Fi Docking Station
4.1 USB Hard Disk mode
The docking station can act as an external hard drive when it is connected to
a computer through USB cable.
1. Insert the hard drive into the docking station, making sure to place it in
the correct direction.
2. Make sure the HDD is firmly connected to the SATA connector.
3. Connect the USB 3.0 cable to the docking station and to an available
USB port of your computer.
4. Connect the power cable to DC power input of the docking station and to
an electrical power outlet.
5. Turn on the docking station pressing the power button.
6. The computer will automatically detect the new hardware and the hard
disk will be visible and accessible by the operating system as a standard
external drive.
Note:
The Wi-Fi interface is automatically turned OFF when the docking
station is connected via USB cable.
4.2 Wireless Hard Disk mode (Wi-Fi direct connection)
Please follow the steps below to use the docking station as a wireless
storage drive.
1. Insert the hard drive into the docking station, making sure to place it in
the correct direction.
2. Make sure the HDD is firmly connected to the SATA connector.
3. Connect the power cable to DC power input of the docking station and to
an electrical power outlet.
4. Turn on the docking station pressing the power button.
5. Please wait at least 40 seconds for the Wi-Fi signal to be ready.
6. Open the wireless utility of your operating system and connect to
“Hamlet-WiFiDisk-XXXX” wireless network.
7. When requested, input the Wi-Fi key. The default password is
“az48486y”.
Your device is now connected to the docking station over a wireless
connection.
Please refer to chapter 5 of this manual to learn about the different ways to
access the hard disk data.