Hamilton Jet HJ212, Installation And Service Manual

Page: 125 / 198

Installation and Service Manual
Appendix
Tailpipe Fairings Without Locking Devices
Loctite Colour Primer, Activator, Accelerator Loctite Cure Speed without Primer
Activator, Accelerator
680
GREEN Type Drying Time Partial Full
Primer 7471 30-70 Seconds 5 Min 4-6 Hrs
Tailpipe fairings without locking devices (extra high strength retaining).
1 - Apply primer to spigot of fairing and allow to dry.
2 - Apply Loctite to spigot bore of tailpipe.
Fit using normal methods.
Nuts on Studs and Bolts (Where Specified)
Loctite Colour Primer, Activator,
Accelerator
Loctite Cure Speed
243 BLUE Type Drying Time Partial Full
Primer 7471 30-70 Sec With Primer 10 Min 2 Hrs
(Optional) n/a Without Primer 20 Min 6 Hrs
222 PURPLE Primer 7471 30-70 Sec With Primer 10 Min 2 Hrs
(Optional) n/a Without Primer 20 Min 6 Hrs
Nuts (low strength thread locking).
Primer is used to shorten the cure time when the temperature is below
15°.
1 - Apply optional primer to the thread of the stud or bolt and allow to dry.
2 - Apply Loctite to the thread engagement area of the stud or bolt in
sufficient quantity to fill all engaged threads.
Tighten nuts to specified torque.
Tailpipe Inserts (Where Fitted)
Loctite Colour Primer, Activator, Accelerator Loctite Cure Speed
263
RED
Type Drying Time Partial Full
Primer 7649 30-70 Sec With Primer 10 Min 2 Hrs
(Optional) n/a Without Primer 20 Min 6 Hrs
Tailpipe inserts (high strength thread locking).
Primer is used in all retaining applications.
1 - Apply primer to the thread of the insert and allow to dry.
2 - Apply Loctite to the female threads in the tailpipe and the threads of the
insert in sufficient quantity to fill all the engaged threads.

There are to be no dry areas between insert and tailpipe threads.
Screw insert into the tailpipe until it bottoms. Tighten firmly.
10-9