Chapter 7. Troubleshooting Guide
EQ-77X LDLS® Operation Manual
23
of
31
Chapter 7. Troubleshooting Guide
7.1 Fault Indicator Block Diagram
See below if any problems are encountered in operating the
EQ-77X.
Condition 1:
Controller Fault and/or Lamp Head Fault LED(s) are ON.
Action 1:
Condition 2:
Lamp fails to ignite after several tries.
Action 2:
Contact
Energetiq.
Fault Indicator Block Diagram
Figure 6.
• Always begin operation of the source by verifying the interlocks.
•
Confirm that the external interlock contact is closed (or that the black jumper plug is fully inserted into the
back of the EQ-99-RC remote control.
• To reset or clear a Fault condition, the actuate the “Operate” switch from the ON position to the OFF position.
If a fault was generated while the “Operate” switch was in the OFF position, first actuate the switch to the ON
position, then to the OFF position. The unit will not turn on if a fault condition exists.
•
If all of the interlocks are OK and either the lamp or controller interlock faults will not clear, please contact the
factory.
