C11440-22CU/C11440-22CU01 Instruction manual_Ver.1.4
9-2 PREPARATION FOR IMAGING
Use the following procedure when start operating the camera.
•
When you connect cables, turn off the power supply of the camera and the peripheral devices.
•
Please change cooling method (cooling mode) if needed. The present cooling mode set-up of
this camera can be checked using DCAM Configurator.
9-2-1
WHEN USING AIR-COOLING
(1) Connect the equipment as shown in Figure 7-1 before operating of the camera.
(2) Turn on the camera.
(3) Check cooling fan is operating properly and air is circulating.
9-2-2
WHEN USING WATER-COOLING
(1) Connect the equipment as shown in Figure 7-1 before operating of the camera.
(2) Turn on the camera.
(3) Turn on the circulating water cooler.
(4) Check cooling water is circulating suitably.
(5) Turn on the cooling switch of the camera from application software.
Note
•
Please refer to the manual of application software for ON/OFF of the cooling switch of
a camera.
9-3 END OF IMAGING
Follow the procedure below when imaging is finished.
(1) End the imaging or transmission of image data with the application software.
(2) Turn off the circulating water cooler. (In the case of water-cooling)
(3) Turn off the camera and peripheral devices.
23
